All models were 18 years of age or older at the time of depiction. This site is creme de mures with RTA label. Parents, you can easily block access to this site.
Please read this page for more informations. We present the hottest Italian classic free porn tube videos. Italian babes, Italian pornstars and Italian pussies. This site owners don’t have any relation to links provided on this site.
All links contained in this web-site are to models 18 years of age or older and provided by 3th partyes. Subaru’s EJ255 engine was a turbocharged 2. The EJ255 engine had a die-cast aluminium block with 99. 5 mm bores and a 79. 0 mm stroke for a capacity of 2457 cc.
The EJ255 engine had a semi-closed deck design whereby the cylinder walls were attached to the black at the twelve, three, six and nine o’clock positions. Compared to its EJ207 predecessor, the EJ255 cylinder block had a new high strength, cast steel alloy rear main journal to reduce bearing oil clearance during cold operation and, as a result, reduce vibration and bearing rumble noise during the warm-up phase. Furthermore, this reduced bearing oil clearance was maintained when the engine was at operating temperature. Each corner formed by a journal or pin and a web underwent a fillet-rolling process to increase its strength. The connecting rods for the EJ255 engine were made from forged high carbon steel, while big end cap dowel pins and set screws were used for accurate mating. The piston head and ring grooves were coated with Alumite, while the piston skirts had a molybdenum coating to reduce friction.
Each piston in the EJ255 engine had three rings: two compression rings and one oil control ring. Of these, the top piston ring has inner bevels and the second piston ring has a cut on the bottom outside to reduce oil consumption. The EJ255 engine had a low pressure cast aluminium cylinder head that was mounted on a head gasket which consisted of three stainless steel sheet layers. Each camshaft was supported at three journals, held in position by three camshaft caps and had a flange which fitted the corresponding groove in the cylinder head to receive thrust forces. Relative to the EJ207 engine, it is understood that camshaft mass for the EJ255 engine was reduced by 1700 grams through the use of hollow shafts and sintered cam lobes.